[. . . ] Guests) from deleting or changing program settings and/or modifying picture and sound settings. After switching on, the TV will always start on the specified program and volume level. If it is in Analogue mode, press the A/D (Analogue/Digital) key on the Remote Control to enter the Digital mode. Press the (Menu Digital) key on the Remote Control Press the Up/Down Arrow Key to scroll to the item called INSTALLATION and press the Right Arrow Key Press the Up/Down Arrow Key to scroll to the item called SERVICE SETUP and press the Right Arrow Key Press the Up/Down Arrow Key to scroll to the item called REINSTALL ALL SERVICES and press the Right Arrow Key Press the Up/Down Arrow Key to scroll to the item called SEARCH and press OK to start the scan. [. . . ] Important : Do not switch off the TV and the mains when a recording has been programmed. 2 Use the ï key to enter into the Preset/ Service list or press Æ key to access Today list. Name Service Enter your pin code if locked Day & Month Start time End time Audio language 5 Press the RED key to store your recording. You can press the GREEN key to display the list of recordings you have set. 6 If you have finished watching television, you must leave it in standby in order for the recording programme to be activated. Important Do not switch off the TV and the mains when a recording has been programmed. 7 If you are watching another digital channel when the timer is due to start, the timer alarm will sound and present you with the option of switching channels or continuing to watch the current channel. Note Your future recording might be interrupted or affected if you press either the or key immediately when the set is wakeup from standby. Future recording might also be interrupted or affected when either EXT 1/ EXT 2 source is connected when the set is wakeup from standby. To avoid the interruption of your future recording, it is recommended that you stay in digital mode for about a minute if a recording has been programmed. 3 When you have finished watching teletext, select a different channel with P ­ / + keys or follow the on screen instructions to return to picture. (If you have inserted a module, check that it is fully inserted in the correct manner as mentioned in step 3 above). The functions that now appear on screen are dependent on the contents of the selected Conditional Access Module in your country. This menu allows you to automatically search for all the analogue programmes available in your region. Before you automatically search for all the analogue programmes, ensure the TV is in analogue mode. If it is in digital mode, press the (Analogue / Digital) key to enter the analogue mode. If you interrupt search during auto store, not all channels will be stored. For all channels to be stored, you need to do a complete auto store search again. If this is not the case, you can use the Sort menu to number the programmes to your preference. aCI (Automatic Channel Installation) feature If a cable system or a TV channel which broadcasts ACI is detected , a programme list appears. Without ACI broadcast, the channels are numbered according to your language and country selection. If you want to change the Language or Country, you have to exit Analogue mode and enter into Digital mode to do so (refer to "Preferences"on page 18). [. . . ] Programming the SmartLoader with the settings from the Master TV Follow these steps to program the SmartLoader with the settings of the Master TV. a) Wireless method Set the SmartLoader to "Wireless" mode using the side switch. Turn on the TV, and while holding the SmartLoader, point it in the direction of the TV. Turn on the TV, and while holding the SmartLoader, point it in the direction of the TV. [. . . ]